EMS - Industrial Sensors and Controls 

 Home Products Order Contact
1-800-5140-EMS (367) Economical Solutions - Reliable Products - Personal Service
Current Loop  $50 buy

in stock
Relative Humidity Transmitter 

 

FEATURES  
                Two wire current loop (4-20 mA)
  1/2" threaded PVC housing - 2" long
  Low cost humidity measurement for PLCs and control systems
  Comes with two mounting nuts
  +/- 4% accuracy
  Reverse polarity protected

 

HOUSING  
  PVC 2" long 1/2 x 13 threads

 

MECHANICAL  
  PVC 2" long 1/2 x 13 threads

 

OUTPUT  
 

 

WIRING  
 

 

SPECIFICATIONS H1
RANGE 0 to 100% RH
ACCURACY +/- 4%

OUTPUT

 Current loop (4-20mA) two wire 
MOUNTING HOLE 1/2"
THREADS 1/2 x 13
HOUSING PVC  IP34

Part Number H1

 

Accessories description Price  
SMB1-050/088 Sensor mounting bracket 1/2" and 7/8" holes $5
SJB1-050 1/2" sensor junction box w/side gland $15

 

 

 

Design considerations

The H1 is a low cost way to input humidity information into a PLC, process control meter, distributed control system (DCS), or other industrial control system. The H1 can be mounted through any 1/2" hole and the two wires connected to an analog input card or other two wire 4-20 mA current loop circuit.

The H1 is designed for low cost applications where standard accuracy is acceptable.

The best readings are taken in moving or circulating air. Stagnant air can allow pockets of variable humidity to develop that may affect measurement accuracy.

Direct exposure to sunlight can cause warming that may affect reading accuracy.

Because the H1 has a PVC housing,  care should be taken to insure that the operating environment does not get so hot that the PVC housing will soften. This may happen at temperatures around 180 to 190 degrees F.

Can be ordered with shielded PVC instrumentation cable upon request.

The T1 should not be used as the sole sensing element in critical equipment or safety applications. 

 
 

EMS  47745 - 193rd St. Toronto SD 57268 USA (605) 794-2072 (P)     (605) 794-2073 (F)  email